I have only tried paper, card board, and wood (for engraving). I have not yet attempted other materials.
I was able to cut through paper/card board stock up to 0.27mm thick in a single pass cut. See Creality CV-01 for more details.
I have only tried paper, card board, and wood (for engraving). I have not yet attempted other materials.
2 Comments
Gladys
1/23/2022 07:11:57 pm
I am thankful for your article, I am marking in favorites , have you tried acrylic engraving with this machine?
Reply
Gladys
1/29/2022 02:24:26 am
I left out a word in my previous question, I should have said, have you tried acrylic or other mediums since this post. this post was 2021 and now 2022. To go with that question have you done any more with this machine since this blog and if so would you be willing to share more information. I was given one of these for Christmas but there's not much out there and I am trying to learn all I can, the software is minimal and since it does not hook to a computer can't really use other software, and the information you have given is the best information I have found. I will check back periodically to see if you have updated this page, and if not well thank you for the information you have posted
Reply
Leave a Reply. |
Updates
I will list additional DXF shape artwork files that are added to the website here. Archives
November 2021
Categories |